All our Products are compatible with FS2020, X-Plane11, DCS, etc...
The TBM is a 3D PLA+ printed kit that can be installed effortlessly on any Puma.
The kit includes all you need to add spring loaded toe brakes to the push-pedals, featuring individual axis for Left and Right brakes.
The kit can be ordered as a standalone order for post modification, or can be ordered with any new Puma PAS or RTF.
You can see a sample post modification installation animation here
General Features:
- Independent left and right spring loaded Toe Brakes
- Variable brake signal (not just on/off operation)
- Compatible with all Puma units
- Plug & Play as with any Pro Flight Trainer products 
- Custom down-loadable .joy file for easy XPlane 11 setup
Toe Brake Modification Kit includes:
- Left and right 3D PLA+ printed Toe Brakes 
- Mounting hardware and wiring
- New pedal tube end caps
- Installation instructions
April 23, 2019 by Christopher Wiebe

Leave a comment

Please note: comments must be approved before they are published.